COPYSTAR CS 2030 DRIVER

Purpose To check the current setting of the maintenance items, or paper jam or service call occurrences. Purpose When performing respective image printing adjustments, used to check the machine status apart from that of the scanner with a non-scanned output VTC-PG pattern. Remove the screw and detach the connector, and then remove the fixing unit thermistor. Connector Figure 3. Check if the job eject pulley, job eject roller Grease the bushings and gears. Loop the scanner wires around the inner grooves in the pulleys on the mirror 2 frame, winding from above to below. Change the setting using the numeric keys.

Uploader: Nalabar
Date Added: 8 October 2017
File Size: 12.83 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 11925
Price: Free* [*Free Regsitration Required]

U Checking scanner operation Description Simulates the scanner operation under arbitrary conditions.

Purpose Used if margins are not correct when the optional DF is used. The original size is correctly. U Initial setting for the developer Description Automatically sets the toner sensor control voltage and toner feed start level for the installed developer. U Setting the maintenance cycle Description Displays and changes the maintenance cycle.

Table of Contents Add to my manuals Add. To remove paper jammed in the copier, open the front cover, paper conveying unit or drawer. Also check for continuity within the fan motor 3 connector connector cable.

  COMSTAR 250G DRIVER DOWNLOAD

Copystar CS OEM Toner Cartridge – 11, Pages – QuikShip Toner

Copustar paper feed from the lower drawer. When fitting the wires, be sure to use those specified below. Cleaning spiral Lower cleaning seal Cleaning blade Drum Remove the transfer roller unit see page Check if the rollers and gears operate Grease the bushings and gears.

The exposure lamp lights. The developing unit consists of the developing roller where a magnetic brush is formed, the clpystar blade and the developing spirals that agitate the developer. Primary feed conveys paper from the upper drawer, lower drawer or bypass tray to the left and right registration rollers, at which point secondary feed takes place and the paper travels to the transfer section in sync with the printing timing. U Setting the continuous detection time for remote switching cont.

COPYSTAR CS SERVICE MANUAL Pdf Download.

Connect the power cord. Sets if the V.

If necessary, protect it with a cable cover or other appropriate item. Subscription telephone line Compatibility The upper three of the five digits indicate general classification of the error and its cause, while the lower two indicate the detailed classification.

Copystar CS-2030 Service Manual

QS- TradeMark Disclosure: Page 2 Contents of maintenance mode items Maintenance Description item No. OEM Products come with a manufacturer warranty only. A selection item appears. U Setting the system 1 Description Makes settings for fax reception regarding the sizes of the fax paper and received images and automatic printing of the protocol list. Remove the charger assembly see page 1- Purpose It is not necessary to run this maintenance item if a key card is installed on a V specification machine.

  MACKIE 1640 ONYX DRIVER

By repeatedly turning the laser on and off, the laser scanner unit forms a latent image on the drum surface. Stapler drive gear Stapler motor Stapler self-priming Stapler cam Stapler cam sensor U Setting the surface potential Description Changes the surface potential ds changing the grid control voltage.

Copystar CS-2030 Copier (022AX609)

Remove the screw holding each of the fixing heater front and rear retainers and then fopystar retainers. ISU installation requires the following tools: Tungsten wire Main charger assembly Drum U Setting the system communication 3 Description Makes settings for fax transmission regarding the communication.

This manual also for: